Loading...

Solution for oil leakage of linear guide special grinding machine

Time:2018/11/6Author:adminClick: 1703
What should I do if I encounter a leak in a special grinding machine for linear guides? We have been operating grinding machines for many years and have a wealth of experience. The following small series will share with you the solution to the leakage of the special grinding machine for linear guides.

  The dust-proof plate on both ends of the workbench is oily and oily. Generally, the special grinding machine is not carefully assembled. The screws that fix the dust-proof plate gold penetrate the two ends of the guide rail and directly seep out from the guide rail. The solution is special grinding machine screw wrapped tape and glue. Go up again.

  It may be that the oil quantity adjustment is too large. Open the rear oil tank cover and adjust the oil valve switch with a flat-blade screwdriver. The clockwise adjustment is small, and vice versa. The general oil quantity control is first clockwise locking and then turning loose. 1/4 can be.

  The oil groove on the wear-resistant sheet of the linear guide special grinding machine is not opened well. It is too shallow or not in place. The oil can't escape from the side and should be reopened in place. The oil hole is blocked, the oil is forced out of the guide rail, and the oil hole is blocked. Generally, the oil is too sticky or too dirty. Replace the oil or clean the oil circuit. If it is an old surface grinder, the rail is too dirty and the oil circuit is blocked. Clean and change the oil.

  The dustproof plate on both ends of the workbench is oily and oily. Generally, the special grinding machine for the linear guide rail is not carefully assembled. The screws for fixing the dustproof plate are pierced through the two ends of the guide rail, and the oil is directly leaked out from the guide rail. The solution is the special screw for the linear guide rail. Tape the glue and then go in. The float switch of the mercury switch is not flexible, and the oil return is blocked. The flexibility of the float should be improved to make the oil return passage unblocked.

  In addition, Xiao Bian also tells you: before and after the screw leakage, if it is the new linear guide special grinding machine oil leakage, generally the screw front and rear telescopic sheath is not installed, the two screws are not locked or the sealant is not well, if It is the old linear guide special grinding machine that needs to replace the screw sheath and re-seal the sealant.